What Can I Turn This CMF Speaker Into...?

The CMF Speaker S is one of the most moddable speakers I’ve seen. It sounded surprisingly good for a little Bluetooth speaker, but as soon as I saw that the front could pop off, I wanted to see what I could put in its place.

The Front Panel Pops Off

The trick is the removable front panel. I pulled it off the dark gray Speaker S, and the speaker underneath stayed right where it was.

The volume knob is swappable too. Nothing even shares the 3D-print files for the panel and knob, so there’s a starting point if you want to design your own.

From Two Speakers to the PRG Boom

I tried two ways of putting the speakers together. I fitted two speaker bodies side by side into an orange 3D-printed shell. You can also stack them vertically, like I did with the white and turquoise ones.

That’s how I ended up with the PRG Boom, complete with a blue carry handle and two round grilles up front.

Final Thoughts

The boombox is fun, but I think the best part is how small you can start. A different knob is already a mod. What would you print for yours?

See you in the next article!

Next
Next

Could a $5 Kit Save This Stripped iPhone Screw...?